עב
Array ( )

Rental List

There are no items on your list

LECTROSONICS IFB Transmitter UM400

Lectrosonic IFB Transmitter.
  • 5 pin input
  • Removable Antenna
SKU WIR-IFT
Quantity:

The UM400a implements the latest Digital Hybrid Wireless® technology in a classic Lectrosonics belt-pack transmitter. A 5-pin input jack provides taps for low impedance dynamic mics, electret lavalier mics with positive or negative bias and line level inputs. Input gain is adjustable over a 43 dB range to perfectly match the audio input level for optimum modulation, minimum distortion and maximum signal to noise ratio. Input levels are accurately indicated by two LEDs on the control panel.

The innovative servo bias input on the standard 5-pin connector provides a programmable, regulated voltage to accommodate a wide variety of electret microphones

The latest digital/analog hybrid technique is presented in a classic Lectrosonics wireless belt-pack transmitter. 24-bit digital audio is combined with optimized FM to create unprecedented audio quality and RF performance. The RF transmission is an aggressively optimized FM system with +/-75kHz wide deviation for a high signal to noise ratio. The overall system delivers full bandwidth audio frequency response up to 20kHz and the operating range of the finest analog wireless systems. The innovative servo bias input on the standard 5-pin connector provides a programmable, regulated voltage to accommodate a wide variety of electret microphones. It is no longer necessary to install resistive pads for some mics to prevent overload of the input stage, divide the bias voltage down for some low voltage mics, or reduce the limiter range at minimum gain settings. To simplify wiring connectors, a single configuration for all microphones is now available for the UM400a transmitter input, and an alternate wiring configuration works well with all 5-pin inputs on Lectrosonics transmitters. Compatibility with earlier analog Lectrosonics receivers and even some receiver models from other manufacturers is provided by custom firmware emulations built into the DSP code. A simple procedure using the frequency and power switches selects the desired operating mode

2017-02-19_1235

Lectrosonic IFB Transmitter
Headphones

You may also like…

SOUND DEVICES 788T

0.00
Quantity:

UTOPIA Basic Audio KIT

0.00
Quantity:

SOUND DEVICES 664

0.00
Quantity: