FLOWCINE Black Arm

The Black arm comes in two versions. The Black arm Standard is made to work for gimbals and cameras with weight range between 5-13kg (11-28lbs). The Black arm Complete is for users working with higher loads and carries between 5-32kg (11-70lbs). Of course you have the option to upgrade the Standard version into a Complete, if needed.

The Black Standard ships with two 7.0mm springs, that carries the 5-13kg. The Black Complete ships with four 7.0mm springs and four 7.5mm springs, that takes the entire range of 5-32kg. You can use the springs in single (one spring on each side) or dual (two springs on each side) configuration, to precisely achieve the lift needed.

The damping action of all axes, vertical, tilt and roll is created by custom made actuator hydraulic dampers that are fully adjustable. You adjust the damping with a knob that has 22 steps, to precisely dial in the exact amount of damping you need for your shot. The Black Standard ships with one damper for each of the three axes, while the Black Complete ships with a total of six dampers, allowing for dual dampers on each axis if needed, or as spares.

ANTI-VIBRATION MOUNT

Each Black arm ships with one anti-vibration mount (AVM). The main purpose of the AVM is to reduce high frequency vibrations, such as noise from a cars engine. In order to maximise the efficiency of the AVM, you should use the version that matches your load and conditions.
There are two types of AVMs, the original Wire AVM and the new Tranquilizer.
The Wire AVMs comes in five different weight ranges, and is very easy to use. You just put the correct one on and go.
The Tranquilizer has many adjustments to fine tune it’s performance, and may give better results if you have the time and skills to configure it properly.
Pick the one that matches the total weight of everything (gimbal, camera and accessories) you will hang on to the Black arm.